R2HH-6533A-R5
10-port sector/multibeam antenna, 2x 694–960 MHz 65° HPBW and 8x 1710–2180 MHz 4x 33°HPBW, 5x RET with tilt indicators
Features and Benefits
- Uses the 4.3-10 connector which is 40 percent smaller than the 7-16 DIN connector
- All Internal RET actuators are connected in “Cascaded SRET” configuration
- Enhances network capacity through six sectors on high band while maintaining low band coverage layer through three sectors with only three antenna faces
Specifications
General Specifications
Antenna Type | Multibeam |
Band | Multiband |
Grounding Type | RF connector inner conductor and body grounded to reflector and mounting bracket |
Performance Note | Outdoor usage | Wind loading figures are validated by wind tunnel measurements described in white paper WP-112534-EN |
Radome Material | Fiberglass, UV resistant |
Reflector Material | Aluminum |
RF Connector Interface | 4.3-10 Female |
RF Connector Location | Bottom |
RF Connector Quantity, high band | 8 |
RF Connector Quantity, low band | 2 |
RF Connector Quantity, total | 10 |
Remote Electrical Tilt (RET) Information
RET Hardware | CommRET v2 |
RET Interface | 8-pin DIN Female | 8-pin DIN Male |
RET Interface, quantity | 1 female | 1 male |
Input Voltage | 10–30 Vdc |
Internal RET | High band (4) | Low band (1) |
Power Consumption, idle state, maximum | 1 W |
Power Consumption, normal conditions, maximum | 8 W |
Protocol | 3GPP/AISG 2.0 (Single RET) |
Dimensions
Width | 350 mm | 13.78 in |
Depth | 208 mm | 8.189 in |
Length | 1580 mm | 62.205 in |
Net Weight, with installed actuator | 25 kg | 55.115 lb |
Array Layout
Click on image to enlarge. |
Beams Configuration
Click on image to enlarge. |
Port Configuration
Click on image to enlarge. |
Electrical Specifications
Impedance | 50 ohm |
Operating Frequency Band | 694 – 960 MHz | 1710 – 2180 MHz |
Polarization | ±45° |
Total Input Power, maximum | 1,000 W @ 50 °C |
Electrical Specifications
Frequency Band, MHz | 694–790 | 790–890 | 880–960 | 1710–1880 | 1850–1990 | 1920–2180 |
Gain, dBi | 14.4 | 14.8 | 14.9 | 15.9 | 16.5 | 17.1 |
Beam Centers, Horizontal, degrees | ±27 | ±27 | ±27 | |||
Beamwidth, Horizontal, degrees | 69 | 67 | 65 | 33 | 32 | 30 |
Beamwidth, Vertical, degrees | 13.5 | 12.3 | 11.5 | 11.9 | 11.2 | 10.6 |
Beam Tilt, degrees | 2–14 | 2–14 | 2–14 | 2–14 | 2–14 | 2–14 |
USLS (First Lobe), dB | 14 | 16 | 17 | 17 | 18 | 19 |
Front-to-Back Ratio at 180°, dB | 32 | 34 | 33 | 31 | 34 | 35 |
Isolation, Cross Polarization, dB | 28 | 28 | 28 | 25 | 25 | 25 |
Isolation, Inter-band, dB | 30 | 30 | 30 | 25 | 25 | 25 |
Isolation, Beam to Beam, dB | 17 | 17 | 17 | |||
VSWR | Return loss, dB | 1.46 | 14.5 | 1.46 | 14.5 | 1.46 | 14.5 | 1.46 | 14.5 | 1.46 | 14.5 | 1.46 | 14.5 |
PIM, 3rd Order, 2 x 20 W, dBc | -150 | -150 | -150 | -150 | -150 | -150 |
Input Power per Port at 50°C, maximum, watts | 300 | 300 | 300 | 200 | 200 | 200 |
Mechanical Specifications
Mechanical Tilt Range | 0°–22° |
Wind Loading @ Velocity, frontal | 254.0 N @ 150 km/h (57.1 lbf @ 150 km/h) |
Wind Loading @ Velocity, lateral | 214.0 N @ 150 km/h (48.1 lbf @ 150 km/h) |
Wind Loading @ Velocity, maximum | 539.0 N @ 150 km/h (121.2 lbf @ 150 km/h) |
Wind Loading @ Velocity, rear | 269.0 N @ 150 km/h (60.5 lbf @ 150 km/h) |
Wind Speed, maximum | 241 km/h (150 mph) |
Packaging and Weights
Width, packed | 460 mm | 18.110 in |
Depth, packed | 372 mm | 14.646 in |
Length, packed | 1867 mm | 73.504 in |
Weight, gross | 38 kg | 83.776 lb |
Regulatory Compliance/Certifications
Agency | Classification |
ISO 9001:2015 | Designed, manufactured and/or distributed under this quality management system |
ROHS | Compliant/Exempted |
CHINA-ROHS | Above maximum concentration value |
UK-ROHS | Compliant/Exempted |
General Specifications
Antenna Type | Multibeam |
Band | Multiband |
Grounding Type | RF connector inner conductor and body grounded to reflector and mounting bracket |
Performance Note | Outdoor usage | Wind loading figures are validated by wind tunnel measurements described in white paper WP-112534-EN |
Radome Material | Fiberglass, UV resistant |
Reflector Material | Aluminum |
RF Connector Interface | 4.3-10 Female |
RF Connector Location | Bottom |
RF Connector Quantity, high band | 8 |
RF Connector Quantity, low band | 2 |
RF Connector Quantity, total | 10 |
Remote Electrical Tilt (RET) Information
RET Hardware | CommRET v2 |
RET Interface | 8-pin DIN Female | 8-pin DIN Male |
RET Interface, quantity | 1 female | 1 male |
Input Voltage | 10–30 Vdc |
Internal RET | High band (4) | Low band (1) |
Power Consumption, idle state, maximum | 1 W |
Power Consumption, normal conditions, maximum | 8 W |
Protocol | 3GPP/AISG 2.0 (Single RET) |
Dimensions
Width | 350 mm | 13.78 in |
Depth | 208 mm | 8.189 in |
Length | 1580 mm | 62.205 in |
Net Weight, with installed actuator | 25 kg | 55.115 lb |
Electrical Specifications
Impedance | 50 ohm |
Operating Frequency Band | 694 – 960 MHz | 1710 – 2180 MHz |
Polarization | ±45° |
Total Input Power, maximum | 1,000 W @ 50 °C |
Electrical Specifications
Frequency Band, MHz | 694–790 | 790–890 | 880–960 | 1710–1880 | 1850–1990 | 1920–2180 |
Gain, dBi | 14.4 | 14.8 | 14.9 | 15.9 | 16.5 | 17.1 |
Beam Centers, Horizontal, degrees | ±27 | ±27 | ±27 | |||
Beamwidth, Horizontal, degrees | 69 | 67 | 65 | 33 | 32 | 30 |
Beamwidth, Vertical, degrees | 13.5 | 12.3 | 11.5 | 11.9 | 11.2 | 10.6 |
Beam Tilt, degrees | 2–14 | 2–14 | 2–14 | 2–14 | 2–14 | 2–14 |
USLS (First Lobe), dB | 14 | 16 | 17 | 17 | 18 | 19 |
Front-to-Back Ratio at 180°, dB | 32 | 34 | 33 | 31 | 34 | 35 |
Isolation, Cross Polarization, dB | 28 | 28 | 28 | 25 | 25 | 25 |
Isolation, Inter-band, dB | 30 | 30 | 30 | 25 | 25 | 25 |
Isolation, Beam to Beam, dB | 17 | 17 | 17 | |||
VSWR | Return loss, dB | 1.46 | 14.5 | 1.46 | 14.5 | 1.46 | 14.5 | 1.46 | 14.5 | 1.46 | 14.5 | 1.46 | 14.5 |
PIM, 3rd Order, 2 x 20 W, dBc | -150 | -150 | -150 | -150 | -150 | -150 |
Input Power per Port at 50°C, maximum, watts | 300 | 300 | 300 | 200 | 200 | 200 |
Mechanical Specifications
Mechanical Tilt Range | 0°–22° |
Wind Loading @ Velocity, frontal | 254.0 N @ 150 km/h (57.1 lbf @ 150 km/h) |
Wind Loading @ Velocity, lateral | 214.0 N @ 150 km/h (48.1 lbf @ 150 km/h) |
Wind Loading @ Velocity, maximum | 539.0 N @ 150 km/h (121.2 lbf @ 150 km/h) |
Wind Loading @ Velocity, rear | 269.0 N @ 150 km/h (60.5 lbf @ 150 km/h) |
Wind Speed, maximum | 241 km/h (150 mph) |
Packaging and Weights
Width, packed | 460 mm | 18.110 in |
Depth, packed | 372 mm | 14.646 in |
Length, packed | 1867 mm | 73.504 in |
Weight, gross | 38 kg | 83.776 lb |
Click on image to enlarge. |
Click on image to enlarge. |
Click on image to enlarge. |
Regulatory Compliance/Certifications
Agency | Classification |
ISO 9001:2015 | Designed, manufactured and/or distributed under this quality management system |
ROHS | Compliant/Exempted |
CHINA-ROHS | Above maximum concentration value |
UK-ROHS | Compliant/Exempted |
Documentation & Downloads
Assembly Drawing
Product Information
Product Specification
Warranty
Assembly Drawing
Product Compliance Documentation
Product Information
Product Specification
Warranty
Other Ways to Browse